污水處理廠臭氧處理系統的設計要點
- Title:
- Design Key Points of Ozone Treatment System in WWTPs
- 關鍵詞:
- font-size: 10pt; ">污水處理廠; 臭氧處理系統; 工藝設計; 安全生產
- 摘要:
- 臭氧氧化工藝在混有較高比例工業廢水進入的城鎮污水處理廠及對出水水質要求較高的再生水廠已有廣泛應用，但臭氧處理系統較之常規污水處理工藝又有其明顯的特殊性。為高效、經濟、安全地應用臭氧處理系統，基于臭氧制備原理及發生器正常工作要求、臭氧的物理與化學性質、臭氧工藝目標及其分別對應的經驗工藝參數，并結合相關工程設計、施工與運行案例，探討了臭氧發生器氣源系統、臭氧制備系統、臭氧輸送系統、臭氧投加及反應系統等各階段易忽視的工藝設計、設備選型及施工要點。另外，針對臭氧處理工藝的消防與防爆設計要點、安全儀表的配置進行了歸納總結。
- Abstract:
-
The process of ozone oxidation has a very wide range of application in WWTPs with high proportion of industrial wastewater and reclaimed water plants with high effluent quality requirements, but ozone treatment system has obvious particularity compared with conventional wastewater treatment process. For the purpose of applying the ozone treatment systems efficiently ， economically and safely, based on the principle of ozone generation， the normal operating requirements of generator， the physical and chemical properties of ozone and the ozone process objectives and their corresponding empirical process parameters, combined with relevant engineering design, construction and operation cases, this paper discussed the process design, equipment selection and construction key points of gas source system, ozone generation system, ozone delivery system, ozone dosing and reaction system which were easily neglected. In addition, the fire protection and explosionproof design key points and safety instrument configuration of ozone treatment process were summarized.
相似文獻/References:
[1]孫永利,張維,鄭興燦,等.城鎮居民人均日生活污水污染物產生量測算之產污規律[J].中國給水排水,2020,36(6):1.
[2]范榮桂,劉娜,尹利鵬,等.污泥厭氧催化快速發酵產VFAs的試驗研究[J].中國給水排水,2020,36(11):69.
[3]鎮祥華,余琴芳,萬年紅,等.污水處理廠二級出水深床濾池超深度脫氮研究[J].中國給水排水,2020,36(11):91.
[4]趙美玲,朱濤,馮江,等.水力模型在合流制調蓄池進水管改造中的應用[J].中國給水排水,2020,36(07):114.
[5]朱一文,王文亮.基于水文方法的暴雨調節塘規模計算[J].中國給水排水,2020,36(07):118.
[6]李駿飛,李歡,楊磊三.粵港澳大灣區創新治水模式分享[J].中國給水排水,2020,36(08):1.
[7]李激,王燕,熊紅松,等.城鎮污水處理廠消毒設施運行調研與優化策略[J].中國給水排水,2020,36(08):7.
[8]趙錫鋒,李興強,李軍.好氧顆粒污泥技術中試研究及應用進展[J].中國給水排水,2020,36(08):30.
[9]王建西.PTA2O工藝用于養豬廢水處理及其Anammox現象分析[J].中國給水排水,2020,36(08):56.
[10]高海英,鄧磊,侯曉慶,等.MBR工藝在西安經開草灘污水處理廠中的應用[J].中國給水排水,2020,36(08):63.
[11]莫俊鋒,王文亮,白獻宇,等.基于設計暴雨法的CSO調蓄池池容計算方法探討[J].中國給水排水,2020,36(08):77.
[12]郭健.納入大直徑熱力管的綜合管廊設計研究[J].中國給水排水,2020,36(08):82.
[13]蒙政成,冼萍,黃付平,等.NCMBR工藝在工業園區污水處理工程中的應用[J].中國給水排水,2020,36(08):88.
